Koch Chemie 1K Nano Paint Sealant

The kit is designed to treat 2-3 vehicles. The kit consists of: 250ml 1K NANO paint sealant 75ml dosing bottle - dose for approximately one vehicle + 1 pc application sponge.

Single-component system with nano-technology for long-term paint sealing. This highly advanced single-component system offers not only unprecedented shine and smoothness of the paint, but also protection against alkalis, car wash brushes, aggressive environmental influences, UV radiation and road salt during nano-sealing.

Usage:
Vehicle preparation:

A.       Thoroughly wash the vehicle with a wax-free product - such as active foam. - dilution: foam injector 1:1, sprayer 1:20 or Gentle Snow Foam dilution 50 ml of product per 10 l of water, or via foam injector 1:1

B.      Remove flying rust and industrial dirt using chemical pre-wash or 11 l – the product is not diluted. For better results, break up the product on the bodywork with a sponge. Then rinse the vehicle and dry thoroughly.

Application of 1K Nano - perform in a garage or covered area and use rubber gloves during application:

A.      Apply 1K Nano to a vehicle that has a smooth surface, i.e., no scratches or holograms. In this case, it is a completely new vehicle. For an older vehicle, a smooth surface can be achieved by using abrasive paste and then using anti-hologram polishing paste, see the second point on vehicle polishing B and D.

B.      Thoroughly degrease the vehicle body using a degreaser, wax remover product. Spray the degreaser onto the bodywork and wipe dry with a blue microfiber cloth. 

C.      Application: First, pour 1K Nano into the applicator (small plastic bottle) included in the package (1x full applicator = car the size of a Škoda Superb Combi). Then apply the product to a black sponge and apply to the bodywork with small circular movements (see photo). Always apply 1K Nano gradually, section by section of the bodywork. Allow the product to dry on the bodywork for approximately 7 – 10 minutes, then thoroughly polish with a blue edgeless microfiber cloth. After three hours, polish the vehicle with a new (clean) blue edgeless microfiber cloth and allow to cure for another three hours. The vehicle is then sealed.

______________

Signal word: danger

Hazard pictograms: GHS07, GHS02, HGS08, GHS09

Standard hazard statements:
- H225 Highly flammable liquid and vapour.
-H319 Causes serious eye irritation.
- H304 May be fatal if swallowed and enters airways.
- H336 May cause drowsiness or dizziness.
- H411 Toxic to aquatic life with long lasting effects.

Precautionary statements:
- P101 If medical advice is needed, have product container or label at hand.
- P102 Keep out of reach of children.
- P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
- P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
- P271 Use only outdoors or in a well-ventilated area.
- P273 Avoid release to the environment.
- P280 Wear protective gloves/protective clothing/eye protection/face protection.
- P301+P310 IF SWALLOWED: Immediately call a POISON CENTER or doctor.
- P312 Call a POISON CENTER or doctor if you feel unwell.
- P331 Do NOT induce vomiting.
- P405 Store locked up.
- P501 Dispose of contents/container to an approved waste disposal site.
- EUH 066 Repeated exposure may cause skin dryness or cracking.
The mixture does not contain any substance that has an adverse effect on the endocrine system. (less than 0.1%)